Chemtrol Australia Product - Injection Fittings

Injection Fittings

Prevents backflow from a treated line

Installation Location: Discharge line (injection point)

For Use With: 1/4″ and 3/8″ O.D. tubing


Description

1/4″ and 1/2″ Male NPT for pipe installation.

Available tubing connection sizes:

  • 1/4″ tube
  • 3/8″ tube

Prevents backflow from a treated line

Installation Location: Discharge line (injection point)

For Use With: 1/4″ and 3/8″ O.D. tubing


The Injection Fitting is designed to install directly into either 1/4″ or 1/2″ female pipe threads (NPT). You can trim the injection point (nose) if needed.

The nose section is designed to inject the chemical away from the wall of your pipe.

TWO INSTALLATION OPTIONS:

Install the Injection Fitting directly into a tee fitting

  • The solution must inject directly into the flow stream.
  • Use PTFE® thread sealing tape on the pipe threads of the Injection Fitting.
  • This illustration shows the Injection Fitting installed in a tee fitting using the 1/2″ threads.

Injection Fitting - Diagram

Install Injection Fitting directly into pipe

  • Drill the correct size hole and then tap the hole for 1/4″ or 1/2″ NPT.
  • Use PTFE® thread sealing tape on the pipe threads of the Injection Fitting.
  • This illustration shows the Injection Fitting installed directly into pipe using the 1/4″ threads.

Injection Fitting - Pipe